Hiller X-18
 | This article includes a list of general references, but it lacks sufficient corresponding inline citations. (June 2010) |
| X-18 | |
|---|---|
| |
| Ground testing the X-18 tiltwing | |
| Role | Experimental prototype |
| Manufacturer | Hiller Aircraft Corporation |
| Designer | Stanley Hiller Jr |
| First flight | 24 November 1959 |
| Status | Aircraft scrapped Template:Avyear |
| Number built | 1 |
| Developed from | Chase YC-122 Avitruc |
The X-18 was an experimental cargo transport aircraft designed to be the first testbed for tiltwing and VSTOL (vertical/short takeoff and landing) technology.
Development
Design work started in 1955 by Stanley Hiller Jr and Hiller Aircraft Corporation received a manufacturing contract and funding from the U.S. Air Force to build the only X-18 ever produced.
To speed up construction and conserve money the plane was constructed from scavenged parts including a Chase C-122 Avitruc fuselage and the turboprops came from the Lockheed XFV-1 and Convair XFY-1 Pogo experimental airplanes program. The tri-bladed contra-rotating propellers were a giant 16 ft (4.8 m) across. The Westinghouse turbojet engine had its exhaust diverted upwards and downwards at the tail to give the plane pitch control at low speeds.
Service history
The first test flight was on November 24, 1959, ultimately recording 20 flights out of Edwards AFB. A number of problems plagued the X-18 including being susceptible to wind gusts when the wing rotated, acting like a sail. In addition the turboprop engines were not cross-linked, so the failure of one engine meant the airplane would crash. Thrust control was through throttle changes, which were too slow for acceptable height and roll control.
On the 20th and final flight in July 1961, the X-18 had a propeller pitch control problem when attempting to convert to a hover at 10,000 ft and went into a spin. The crew regained control and landed, but the X-18 never flew again. However ground testing of the tiltwing concepts continued. Eventually a VTOL Test Stand was built on which the X-18's vertical takeoff and landing and hover control was to be tested. One engine run was successfully conducted to the full 15-foot wheel height on the VTOL Test Stand. The program was cancelled on January 18, 1964 before further VTOL Test Stand testing could be conducted, and the X-18 was cut up for scrap.
The program proved several things that contributed to further tilt-wing VSTOL technology programs:
- cross-shafting between the engines was mandatory in order to avoid loss of control in the event of an engine failure.
- direct propeller pitch control was mandatory for precise height and lateral control during VTOL and hover.
This knowledge was employed in the successful development and flight tests of the Tri-Service Hiller-Vought-Ryan XC-142A, tilt-wing VSTOL transport.
Specifications (X-18)
 |
This aircraft article is missing some (or all) of its specifications. If you have a source, you can help Wikipedia by adding them. |
General characteristics
- Crew: 2-3
Performance
See also
Related development
Aircraft of comparable role, configuration, and era
Related lists
External links
